KH keeper update to 0.6.1 or higher

If you are having issues with the last updates, please follow the steps below. Remember that in both cases, the device has to be reconfigured and recalibrated.

If you’ve updated the KH Keeper to 0.6.0 but in the Smart Reef system, it says that the device is offline and the colour of the KH Keeper’s LED is white, please connect to the device directly and go through the setup procedure. In this case, is only required to configure the device and you can skip the calibration part.

You can find more information about the setup procedure in the manual or in this article How to set up your KH Keeper

If your device is configured and connected to your Smart Reef account, please look over the list of your devices. Find a red exclamation mark over one of the icons next to KH Keeper on the list. Tap on the icon and begin the update to 0.6.1. Now please wait until LED in your device turns white.

When the light turns white it means that the update has finished. Please connect to the device directly just like on the initial setup and proceed with the configuration of the KH Keeper. You will be required to recalibrate the whole device after you’ve set it up.

Please go to your Smart Reef account and look over the list of your devices. Find a red exclamation mark over one of the icons next to KH Keeper on the list. Tap on the icon and begin the update to 0.6.1. Now please wait until LED in your device turns white.

When the light turns white it means that the update has finished. Please connect to the device directly just like on the initial setup and proceed with the configuration of the KH Keeper. You will be required to recalibrate the whole device after you’ve set it up.

You can find more information about the setup procedure in the manual or in this article How to set up your KH Keeper

Reef Factory Support

KH keeper update to 0.6.1 or higher

Analytics

Related content