| Expand | ||
|---|---|---|
| ||
The KH Keeper keeper measures water from the aquarium. If kH drops too quickly between measurements the device will repeat the test and if the result is confirmed will send a notification to the user. An aquarist can set a value in the measurement difference. The tested water can be returned to the aquarium or go to the waste container, depending on user preferences. Everything is controlled by the Smart Reef reef application and can be connected with our other devices. |
| Expand | ||
|---|---|---|
| ||
To run the device at your aquarium, you only need access to your home WiFi network, electricity, a mobile device (smartphone, tablet, computer or laptop) with the Smart Reef reef application installed and our reagent solution. |
| Expand | ||
|---|---|---|
| ||
You can place the KH keeper wherever you want so that it has access by the hoses to the aquarium, water waste and reagent solution. The device is designed in such a way that you can place it in a visible place or hang it on the wall. |
| Expand | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||
To prepare the solution You will need RO water. For every 1 unit of reagent, You will need 9 units of RO water. Remember to use precise amounts of each liquid for the mixture as it is very important for KH Keeper keeper to function properly. Table The table below contains volumes of liquids used to prepare a set amount of solution.
|
| Expand | ||
|---|---|---|
| ||
You can place the KH Keeper wherever you want so that it has access by the hoses to the aquarium, water waste and reagent solution. The device is designed in such a way that you can place it in a visible place or hang it on the wall. | ||
| Expand | ||
| ||
The magnet included in the kit is used to reset the device. If you want to restore the device to factory settings, apply the magnet to the area marked “RESET” above the hoses plugs and hold for 5 seconds. After this time, the device turns off and restarts. This means that the device has been reset. |
...
| Expand | ||
|---|---|---|
| ||
KH Keeper keeper can make corrections using the connected dosing pump. This function allows the precise control of the KH parameter to the level determined. It will soon work also with calcium reactors and 3rd party pumps via Power Switcher. |
| Expand | ||
|---|---|---|
| ||
Yes. You can turn on or turn off the light indicator in the Smart Reef reef application by clicking the SETTINGS button. |
| Expand | ||
|---|---|---|
| ||
Check that all connectors are connected together, then check that the hose is not damaged, e.g. frayed or broken. Check if the hose in the pump head is not chafed and if the tubes in the beaker are properly installed (inserted into the plastic connectors). It is very important that the The water filter must be completely submerged in the water, and its elements must not protrude above the water. After correctly placing the water filter inside the water, please click the “fill the circuit” button to pump out air bubbles and fill the full circuit with water. |
| Expand | ||
|---|---|---|
| ||
It’s very important to keep close measure over the reagent doses and because we want you to achieve precise results when you are using your KH Keeper keeper we’ve chosen a special motor for our reagent pump. It’s a step motor which is much more precise than a regular one. However, they tend to make more noise than regular pumps. |